When the computer is booting up, I get the massages that the profiles for both monitors have been loaded successfully and the screens change, however, almost immediately the screens change back again - as if the profile was loaded and then unloaded again. The profiles have been loaded into the colour management settings on the display driver software and the profiles can be seen on the 'Profile Chooser' (part of the Spyder software package). I could not find a way to tell the Spyder software which monitor I wanted to calibrate.īack on topic. The meant that I had to swap the monitors around within the graphics card setup to force the Spyder software to open on the second monitor. ![]() Moving off topic for a second - I found it awkward to calibrate two monitors because you cannot move the Spyder calibration window from one monitor to the other. After quite a lot of messing around with my monitor set-up (I have two monitors LCD and CRT) I managed to generate a profile for both. I took the plunge and bought a Spyder 2 to calibrate my monitors.
0 Comments
Leave a Reply. |